install 64 bit plex media server raspberry pi

Which is almost but not quite the same as the Pi3. WiFi needs three firmware files from in /lib/firmware/brcm/:

The 4G RAM Pi 4 can build the 64 bit kernel in about an hour but a 64 bit toolchain is required, so the very first kernel cannot be built natively on the Pi.īuild and install the kernel, device tree, and kernel modules an described in Raspberry Pi 3 article.īuild and install the device tree and overlays by running make dtbs, then copy the resulting device tree and overlay files to /boot dto file to be loaded as well as kernel support.

CPU governors can be controlled in /proc or the default CPU governor can be changed to be ondemand. The default CPU governor (CPU_FREQ_DEFAULT_GOV) is powersave. Unlike bulk mode, it allows commands to USB storage devices to be overlapped.Įnable USB Attached SCSI in the kernel if a USB3 storage device will be used. The Pi 4 USB 3 supports USB Attached SCSI (CONFIG_USB_UAS). User $ ARCH=arm64 CROSS_COMPILE=aarch64-unknown-linux-gnu- make bcm2711_defconfigĬheck the other kernel configuration settings given in configure the kernel. Get the aarch64-unknown-linux-gnu cross toolchain. Pi specific: it needs a fat32 partition to boot from, and it does not use a regular bootloader. You may cross compile the kernel as described below, but I suggest installing qemu with static aarch64 user emulation and then treating it as a standard Gentoo installation, following similar to the AMD64 Handbook after taking into account the rest of the Pi specific notes on this page, copying over /usr/bin/qemu-aarch64 to the /mnt/gentoo/usr/bin/ after unpacking the ARM64 stage 3. Read the next paragraph about what is untested.

Install 64 bit plex media server raspberry pi